If an Error is displayed after clicking the button, or the Basic Settings status does not switch to On, let the selected group and procedure finish on its own. Some modules do not require the use if the button.NOTE: If the test drive cannot be performed in the recommended way or the necessary time, any remaining adaptations will be performed automatically during normal driving.
VCDS JETTA FULL
Perform one sharp braking followed by a full throttle acceleration (oil return check) while in Drive, Not Tiptronic Mode.
The engine speed window for all gears is 1200 - 3500 RPM (for clutch calibration). While doing that make sure to drive in Gears 3 or 5 for approx. Fluid Temperature 30.100 ☌ (86.210 ☏), see Measuring Blocks, Group 019.ĭrive in Tiptronic Mode from stand still up to 6th Gear.Suggested test drive after replacing the mechatronic or successful basic setting. Switch off Ignition, wait 10 Seconds and switch it back on.Ĭheck and clear fault codes after successful test. Reset Values (ESP & Tip Cruise Control Installation) Reset Values (Steering Wheel Paddle Installation) Wait until Basic Settings has switched to ON and all numbers have stopped moving. Basic Settings switches to On when finished: Basic Settings 060 Wait until the numbers quit moving and the trans will quit making noises.When you go to Basic Settings 060 and click GO the screen may look like this: Basic Settings 060.Basic Settings switches to On when finished: Basic Settings 061 When you go to Basic Settings 061 and click GO the screen may look like this: Basic Settings 061.Transmission Tolerances (Engaged Calibration) NOTE: Be sure to perform the following steps in the sequence shown, followed by the defined test drive. Brake Pedal operated (hold for the whole procedure).Engine ON (Idling) for one minute or more.If the original Coding is unknown, coding information can be found in the pop-up balloon within the VCDS function.When replacing this Mechatronic unit, simply copy the coding from the original Auto-Scan and paste it into the New Coding section of the replacement followed by clicking.2.7 Reset Values (ESP & Tip Cruise Control Installation).2.6 Reset Values (Steering Wheel Paddle Installation).
0 kommentar(er)
